Starter strip
The edges get drip edge and starter shingles which keeps wind from peeling up the first course.
Shingle Roofing
Shingle Roof Installation Pequannock, NJ
A Pequannock roofer can help you pick between 3-tab, architectural and impact-resistant shingles and install the full system beneath them, so the roof is sealed against wind-driven rain from the start. Call (862) 458-0110 to reach a local roofer.
Shingles are only the top layer of a shingle roof. Below the shingles go metal drip edge, a self-adhering ice barrier at the eaves and valleys, a layer of underlayment and a starter row at the edges. Flashing and attic ventilation round it out, and most leaks on newer roofs come from those details rather than the shingles.
Shingle choice sets the look, the wind rating and the life of the roof. Most new roofs use architectural shingles, which are heavier and longer lasting than the older flat 3-tab style. Impact-resistant shingles rated Class 4 under the UL 2218 test are an option where hail is common, and some insurers treat them differently, so ask yours.
Not every roof can take shingles. The usual minimum for shingles is a 2 in 12 pitch, with a double layer of underlayment on slopes up to 4 in 12. Porches and low additions often need a different material where they tie into the main roof.
If the problem goes deeper than it first looked, a Pequannock roofer may also recommend shingle roof replacement or roof installation.
Need shingle roof installation in Pequannock? Call (862) 458-0110 and describe the problem to a roofer who works in Pequannock.
Call nowThe process
Building a shingle roof layer by layer
Here is the order a roofer follows on a new shingle roof.
Check the sheathing
The roof deck, usually plywood or OSB, is checked for soft spots, gaps and protruding nails before anything covers it. A wet deck is never covered.
Drip edge at the eaves
Metal drip edge is fastened at the eaves, and a self-adhering ice barrier covers the eaves and valleys where water and ice collect. That membrane seals around nails where ice backs water up.
Underlayment rows
Synthetic underlayment or felt is rolled out in overlapping rows from the bottom up, then drip edge goes on along the rakes over it. Most roofers now use synthetic, which resists tearing and lies flatter than felt.
Set the first course
A starter strip with factory sealant runs along the eaves and rakes so the first course and the edges are glued down. That is where wind damage usually begins on a poorly built roof.
Shingle the field
Each course is nailed in the nailing zone, never high or overdriven, and step flashing goes in piece by piece at every sidewall. Counter flashing laps over the step flashing at chimneys and walls.
Cap the roof
A ridge vent is cut in along the peak and capped with hip and ridge shingles, balanced with soffit intake at the eaves. Too little intake makes a ridge vent pull air the wrong way.
What is included
Parts of a shingle installation
Deck underlayment
A synthetic water barrier goes over every sheet of decking so wind-driven rain has a backup.
Flashing details
New flashing and balanced ventilation finish the system which is where most leaks would otherwise start.
Eave membrane
The lowest edge of the roof gets a sealed membrane to seal around nails if water backs up.
Shingle selection
3-tab, architectural or impact-resistant shingles are matched to the house so the look and performance both fit.
Related service
Architectural Shingle Installation Pequannock, NJ
Architectural shingles go on over the same deck, underlayment and starter as any shingle, with their own nailing pattern. The nails must land in the narrow area where the two laminated layers overlap, or the bottom layer can slip and the wind rating is lost. The ridge and hips get thicker cap shingles made for the line, not cut 3-tab pieces.
In Pequannock, NJ, architectural shingles are the common choice for both new homes and reroofs. They stand up to wind better than 3-tab, hide small dips in the deck and usually last longer. Look at a few colors on a nearby roof in daylight before deciding.
Related service
Asphalt Shingle Roof Installation Pequannock, NJ
Asphalt shingle roof installation is standard work, but the quality varies a lot from one crew to the next. The shingles rarely fail first; the edges, nails and flashing do. It is fair to ask which underlayment and ice barrier will go on and where.
For an asphalt shingle roof installation in Pequannock, plan for a few days of work on an average house. Shingles seal best in warm sun, so roofs installed in cold weather are often hand sealed along the edges. Rain delays are normal because the deck has to stay dry.
Local help
Shingle Roof Installation Near Me
New shingle roofs in Pequannock go on everything from new houses and additions to reroofs of older homes. From Pequannock out to neighboring towns such as Pompton Plains, Lincoln Park, Towaco and Riverdale, houses built decades ago tend to need ventilation and flashing upgrades when they get a new shingle roof, and a shingle chosen for local wind and hail makes sense anywhere storms roll through. Searching for shingle roof installation near me? Ask how the flashing and ventilation will be handled.
For shingle roof installation in Pequannock, NJ or nearby towns like Pompton Plains, Lincoln Park, Towaco and Riverdale, call (862) 458-0110 to reach a roofer who covers your street.
Roofs in this climate
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Pequannock is busiest after a hard winter and before the next one.
Why call
Why fix it now
Less damage
Small roof problems caught early usually stay small repairs.
Familiar with local homes
Roofers in Pequannock know the roof types and weather wear common in local homes.
Clear next steps
Ask your questions before you agree to anything.
Shingle Roof Installation questions
What kind of underlayment should go under shingles?
The layers beneath shingles are drip edge, ice barrier, underlayment and starter strip, in that general order. Most roofers now use synthetic underlayment instead of felt, since it lies flat and resists tearing. The shingle instructions and local code set the minimum.
Why does nail placement matter on a shingle roof?
Nail count and placement decide how well shingles stay on in wind. Standard nailing uses four nails, and high-wind areas often require six. Each nail has to sit in the nailing zone, flush with the surface, not too high and not driven through.
Can shingles be installed in cold weather?
Warm, dry days give the best results for a shingle install. Cold-weather installs are done regularly, with extra care for brittle shingles and hand sealing where the strips will not activate. Rain and snow are the real limits, since a wet deck should never be covered.
How steep does a roof need to be for shingles?
Shingles are made for slopes of 2 in 12 and steeper. Roofs that are low but still within range get added underlayment protection. Anything flatter needs a membrane roof such as TPO, EPDM or modified bitumen.
What is the difference between 3-tab and architectural shingles?
A 3-tab shingle is thin and uniform, and an architectural shingle is thicker, heavier and layered. For most homes architectural shingles are the better value over the life of the roof. 3-tab still works for sheds, garages or matching an existing roof.
More questions? Call (862) 458-0110
Often needed together
Shingle Roof Replacement
Full shingle roof replacement, from tear-off and deck repair to new shingles and flashing, with soft decking fixed before anything new goes on.
Learn moreRoof Installation
Putting on a new roof the way the material maker intends, so it sheds water at every edge and seam.
Learn moreRoof Ventilation
Balancing attic intake and exhaust with soffit vents, ridge vents and attic fans, based on what the attic actually needs.
Learn moreGutter Installation
Seamless gutter installation sized to the roof, pitched to the downspouts and hung on hidden hangers, with the fascia checked before anything is hung.
Learn more
Looking for something else?
See all roofing servicesGet shingle roof installation help in Pequannock
Call (862) 458-0110 for a local roofer in Pequannock and nearby towns.